Roofing Tar Paper Overlap

Secure the outside edges with plastic capped roofing nails at 12 inch intervals.

Roofing tar paper overlap.

This overhang will ensure water will not enter underneath the paper getting trapped on top of the wood roof planks. This will help give you a moisture barrier on the roof. The overlapping felt creates a secondary barrier for moisture and wicks water away from the shingles above and the sheathing below. Roll the roof paper up and over the peak.

As long as the wood on your roof is in good condition you can go ahead and put tar paper down. Roof felt also known as tar paper is a waterproof fiberglass product. Start at the bottom of the roofline and work up so any water that gets through the roofing material will shed down the tar paper and will not go under it. It is used for temporary roofing for weatherproofing and as an underlayment under shingles or other permanent roofing materials.

As you work the paper can be tacked down in the center so it won t blow away. Once the tar is applied tar paper can be carefully placed on top of the hot tar using a mop to sink the paper into the asphalt. Roofing felt is required to overlap 2 inches over the lower felt course. Make at least three layers.

Once you get close to the top add another layer of felt so that you overlap the ridge of your roof by about 1 foot 0 30 m. Even if there s older tar paper in place you should simply rip it off and replace it. Climb onto the roof and lay a second strip of tar paper above the first strip overlapping it by about 5 inches. Continue overlapping strips up each side of the roof.

Therefore a 2 inch overlap provides redundancy at the edges where the barrier is weakest. Install all subsequent courses with the same overlap until the top edge of the paper is within 6 inches of the roof s peak. Overlapping the tar paper layers to create a seal. Position the next course of tar paper farther up the roof so that its lower edge overlaps the upper edge of the paper in the first course by 1 foot.

Step 6 overlap next roll. Before applying roofing you ll need to cover the sheathing with roofing felt also often called tar paper most local codes call for using 30 pound felt. Experienced professionals never allow the hot tar to clump up or build up in any area. The roofing felt should be applied in layers that overlap.

Staple down the tar paper. Step 4 over the peak. Some roofers prefer to attach felt underlayment with 1 inch roofing nails or special nails with plastic washers but most codes allow staples which are easier to drive.